/ HOW IT GOES TOGETHER
Assembly instructions
Short 3D films showing how our parts fit together, step by step. Tap a card to watch.
▶ 3D FILM · 48 STube ringsRings onto the lower dovetail, moving them to fit your telescope, and the bolts from below.Watch →Printable PDF ↓
▶ 3D FILM · 48 SDovetailsThe upper dovetail across the ring tops, washers on carbon bars and the safety stop bolt.Watch →Printable PDF ↓
▶ 3D FILM · 22 SCarry handleSquare nuts in the bar, the handle on top, bolts in, and picking its spot.Watch →Printable PDF ↓
▶ 3D FILM · 23 SRing spacersSpacers between the dovetail and the rings, with their longer bolts.Watch →Printable PDF ↓
▶ 3D FILM · 21 SDew shieldsLoosening the knobs, sliding the shield over the front, tightening the knobs, then the front cover.Watch →Printable PDF ↓
▶ 3D FILM · 42 SCDK shroud spacersTelescope level, four spacers on each cage with polymer bolts, then the shroud back on.Watch →Printable PDF ↓
▶ 3D FILM · 34 SSide bracketsNuts and hinge plate off, longer bolts and two white washers, the bracket, then the plate and nuts back on.Watch →Printable PDF ↓
See it all on your own telescope, with prices.
Open the 3D builder →
